Choosing between a cylinder-head-temperature (CHT) sensor and an exhaust-gas-temperature (EGT) sensor starts with a simple question: which temperature do you intend to measure, and where will the sensor sit? The names describe different measurement locations; the sensors are not interchangeable just because both connect to a temperature channel.
CHT and EGT measure different locations
AiM describes its CHT thermocouple as fitting between the spark plug and cylinder head. Its EGT thermocouple is placed in the exhaust header pipe. That means the first check is your intended measurement point and the sensor’s physical design—not the label shown on the display.
- CHT: the sensor is installed at the spark-plug/head interface. Peyton Racing’s 14 mm AiM CHT sensor listing identifies it as a cylinder-head-temperature sensor and lists a 14 mm ring, temperature range, and wire length. Verify that the listed dimensions and connection match your engine and data system.
- EGT: the probe is placed in the exhaust header. Peyton Racing’s AiM EGT probe listing describes a 5 mm probe and 30 cm wire. Check the required mounting point, connector, extension or patch cable, and gauge model against the manufacturer’s instructions before ordering.
Why might a MyChron label look unexpected?
AiM’s MyChron 5 FAQ says the unit identifies temperature channels from the connected sensor and sampled temperature. Its channel-label guide says CHT and EGT labels are assigned about 30 seconds after switch-on; a channel labeled CHT can switch to EGT if the sampled temperature exceeds 220°C (428°F). So a displayed label alone does not prove that the wrong sensor is installed. Confirm the sensor, its connection, and the manufacturer’s current guidance before troubleshooting.
Check these details before choosing
- Write down the measurement you need: cylinder head or exhaust gas.
- Compare the actual mounting style and dimensions on the product page with your engine’s specified installation point. For the 14 mm CHT listing, verify the relevant plug/seat dimensions; do not infer fit from “14 mm” alone.
- Confirm your MyChron model, connector, and any required patch or extension cable using AiM documentation. Product listings can describe the sensor without listing every system combination.
- If your display label or reading seems wrong, check AiM’s FAQ for your exact model and current firmware before changing the installation.
For manufacturer references, see AiM’s MyChron 5 temperature-channel labeling guide and AiM’s MyChron 5 FAQ. Review the live MyChron Sensors collection and compare the exact listing details. If model, connector, or mounting fit remains unclear, confirm it with AiM before ordering.